Step #1.  place top of stool on fabric and trace around it.

Step #2.  cut out the circle.  You can add a seam allowance if you want to.  I don’t always because if the fabric has any give to it at all it tends to come out too big and I wish I hadn’t added the seam allowance.  If you DO add the seam allowance and you decide the slipcover turns out too big you can always just take a bigger seam.

Step #3. measure around the stool…

…and measure the height of the stool.  Cut out a piece of fabric the height of the stool plus enough for a hem and seam allowance x the measurement around the stool plus a seam allowance.

Step #4.  Sew the large rectangle together.

You will have a tube.  Press the seam allowance open

Step #5.  Fold the round top piece in half and make small snips at the center on each side.

Fold in half again and mark the centers again with a small snip.  This will give you 4 snips evenly spaced around the circle.

Step #6. Fold the rectangle piece in half with the seam to one side.  Make a small snip at the edge opposite the seam.  This marks the other side.  Then fold in half again bringing the snip you just made even with the seam.  Now make small snips on the opposite fold lines across from the You will now have 3 small snips and the seam evenly spaced on the rectangle piece.

(snip across from the seam)

Step #7.  Pin the circle piece to the rectangle piece (that has been sewed into a tube)

You will match up those small snips.

When you are finished pinning it should look like this.  Fits evenly all the way around with no stress and it is easy to make it happen when you mark your pieces with those little snips!

Step #8.  Sew the seam you just pinned.

Step #9.  Try it on for size.  If you are happy with it at this point and this is the look you were going for, press that seam around the top well, pop the cover back on and viola!! you are finished!

If you would like to spiff up that cover a little, make it a little girly, a little foofy, or if you just love ruffles, continue on – I added a continuous ruffle to the whole thing.

1st step of the ruffle is to cut the strips.  I measured them about 2 1/2 inches and made all my snips first, then tore the strips of fabric.  I love a good raw edge 🙂

They will look like this and you will need a TON of them.  Way more than you see in this photo 🙂

For the ruffling stage I used this wonderful little gadget.  It is one of the best sewing investments I’ve made for awhile!  I love it.  It was around $40 I think and so, so, so worth it.  If you like to make things with ruffles I highly recommend you get one.  If you can’t get one that works with your machine, I recommend a new sewing machine.

Step #3 of ruffle.  Feed the beginning of the strip into ruffler.

You will need a lot of ruffled up fabric for this project. I had to add more ruffled strips to mine halfway through because I didn’t know how much it would take.

Step #4 of ruffle.  After ruffling your strip start sewing it on.  I just started at the bottom and went around.  When I got around to where I started I just moved the ruffle up and went around again.  Around and around and around and around and….

You can kind of see here where I started overlapping the ruffles when I got back to where I had started.

When I got to the top of the side piece I just continued onto the round top piece and went around and around to the center.  Easy peasy!